This view of the Owner’s Manual contains the very latest information, which may vary slightly from the printed Owner’s Manual originally provided with your vehicle. It may also describe content that is not on or operates differently on your vehicle. Please consider the Owner’s Manual originally provided with your vehicle as the primary source of information for your vehicle.
The information contained in this publication was correct at the time of release.In the interest of continuous development, we reserve the right to change specifications, design or equipment at any time without notice or obligation.No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission.Errors and omissions excepted.
Copyright © 2024 Ford Motor Company
Adjusting the Steering Wheel
WARNING:
Do not adjust the steering wheel when your vehicle is moving. |
Note:
Make sure that you are sitting in the correct position. See
Sitting in the Correct Position.
- Unlock the steering column.
- Adjust the steering wheel to the desired position.
- Lock the steering column.
Power Tilt and Telescope Steering Column (If Equipped)
|
WARNING:
Do not adjust the steering wheel when your vehicle is moving. |
Note:
Make sure that you are sitting in the correct position. See
Sitting in the Correct Position.
Use the control on the side of the steering column to adjust the position.
To adjust:- tilt: press the top or bottom of the control
- telescope: press the front or rear of the control.
Easy Entry and Exit Feature
When you switch the ignition off, the steering column will move to the full up and forward position to allow extra room to exit your vehicle. The column will return to the previous setting when you switch the ignition on. You can enable or disable this feature in the information display. See
Information Displays.
Memory Feature
The steering column position saves when you do a memory set function. You can recall it with the memory feature. See
Memory Function.
Pressing the adjustment control during memory recall cancels the operation. The column responds to the adjustment control.
The steering column sets a stopping position just short of the end of the column position to prevent damage to the steering column. A new stopping position sets if the steering column encounters an object when tilting or telescoping.
To reset the steering column to its normal stopping position:
- Press the steering column control again after encountering the new stopping position.
- Continue pressing the control until it reaches the end of the column position.
A new stopping position is set. The next time you tilt or telescope the steering column, it will stop just short of the end of the column position.